Audiovox ACC-52 Black Ground Wire, CAR Antenna Input, Radio Antenna Output, Remote Control Cable

WIRING THE FM MODULE (con't.)

BLACK GROUND WIRE

The 3 foot black wire attached to the FM module must be secured to a grounded metal part of the car’s chassis. If you cannot find an existing bolt or screw to fasten it to, you must drill a hole in the metal and secure it with a screw. To insure a good ground, remove any paint or grease where the wire will connect.

CAR ANTENNA INPUT

Locate your existing car radio antenna cable. This is normally a black cable about as thick as a pencil and will be plugged into a socket on the rear of your car radio. Unplug this antenna lead and plug it into the mating female socket on the FM module.

IMPORTANT - Some Import cars have a special dual antenna called “DIVERSITY ANTENNA”. If your car has this type of antenna system, you will find the antenna cable will not fit the socket on the FM module. Use of the ACC-52 with “DIVERSITY ANTENNA" is not recommended. You may also find some late model GM cars have an antenna plug that is too small to mate with the FM module. If this is found, call Audiovox’s Toll-Free Assistance for a special adaptor. This adap- tor can also be purchased at any car stereo installation center.

RADIO ANTENNA OUTPUT

Attached to the FM module is a male antenna plug. Simply plug this into the socket on the car radio from which you just removed the car antenna cable.

REMOTE CONTROL CABLE

Attached to your remote control is a cable that plugs into the remaining socket on the end of the FM module. Position the remote control near the area you will permanently mount it and route the cable to the FM module. Plug the cable into the FM module.

	EXISTING
GROUNDED METAL PART	SCREW
	OR BOLT
OF CHASSIS

FM MODULE BLACK GROUND WIRE

EXISTING CAR RADIO (UNPLUG ANTENNA CABLE)

EXISTING CAR ANTENNA

FM MODULE

FEMALE CONNECTOR

CAR ANTENNA CABLE

CAR RADIO

FM MODULE

MALE ANTENNA PLUG

MALE ANTENNA PLUG

FM MODULE

REMOTE CONTROL

REMOTE CONTROL CABLE

11