WIRING THE CD CHANGER
DATA CABLE
The 15 foot data cable connects the changer to the FM module. First connect the end of the data cable labelled "TO CD CHANGER" to the socket on the left side of the changer. Route the other end of the cable up to the car’s dashboard area near your existing car radio and plug the data cable into the mating socket on the end of the FM module.
WIRING THE FM MODULE
The FM module should be positioned near your existing car stereo and the 15 foot data cable should be connected to it. Make the following connections to the FM module:
ORANGE WITH WHITE STRIPE WIRE
Attached to the FM module is a 3 foot orange with white stripe wire. This is to be connected to a + 12 volt circuit that is only live when the ignition is on. The best connection point is at the car’s fuse block at the “RADIO” or “ACCES- SORY” identified terminals.
FM MODULE
15 FOOT DATA CABLE
"TO CD CHANGER" LABEL
CAR FUSEBLOCK
"RADIO" OR "ACCESSORY" TERMINAL
FM MODULE
ORANGE w/WHITE
STRIPE WIRE
GREEN WITH WHITE STRIPE POWER WIRE
EXISTING +12 VOLT "LIVE" WIRE
12 VOLT
CAR BATTERY
The 3 foot green with white stripe wire must be connected toa “live” 12 volt wire in the vehicle. You will have to check the wire you connect it to and make certain it is always “live”’ even when the car’s ignition is turned off. If none is found, route the wire to the car’s fuseblock and connect it to a “live” circuit there.
GREEN w/WHITE
STRIPE WIRE
SPLICE INTO "LIVE" WIRE
AND TAPE SPLICE
FM MODULE
15 FOOT EXTENSION LEAD (MAY NOT BE REQUIRED)
10
