Audiovox ACC-52 owner manual Mounting the Remote Control, Mounting the FM Module

MOUNTING THE REMOTE CONTROL

On the back of the remote control you will find an adhesive backed “Velcro” pad. Select the desired mounting area on your car dashboard that will allow ease of use and full visibility of the LCD display. Peel off the protective paper on the adhesive pad. Make certain the dash area is clean of all wax, grease, etc., and press the remote control in place. Allow a 1/2 hour for the adhesive to secure, then you will find the Velcro pads will allow you to remove the remote control for hand-held use if desired and replace it as often as needed.

MOUNTING THE FM MODULE

There are two mounting tabs on the FM module. It can be secured by two methods. Use two screws “C” and drill two 3/32" holes or use electricians tape or twist ties (not provided).

ADJUSTMENT OF FM MODULE TUN- ING

To operate your ACC-52, your car radio must be first tuned to the FM band at 89.1MHz. If you find interference on this frequency, you can change the output frequency from the FM module to 88.7 MHz., by moving the slide switch on the FM module to the 88.7 MHz. position. You will then have to tune your radio to 88.7 MHz. instead of 89.1 MHz. when using your CD changer.

CLEAN MOUNTING AREA

REMOTE

CONTROL

REMOVE PAPER LINER AND PRESS IN PLACE

MOUNTING

SURFACE

FM CONVERTER

FM

MODULE

CAR DASHBOARD

DRILL TWO 3/32" DIA. HOLES

SCREW "C"

(2 PCS.)

SLIDE

SWITCH

12