14
Lighting the Grill Using the Pulse-Spark Ignitor
!WARNING
To reduce the risk of death or serious injury from an explosion or a fire beneath the grill:
•Regularly inspect and clean Burner/Venturi Tubes for insects or insect nests. Spiders or small insects can build nests, webs, and lay eggs in the grill’s Venturi Tubes, (Fig 12, page 20) obstructing the flow of gas to the Burner. The backed- up gas can ignite behind the Control Panel and cause a fire beneath the grill, posing the risk of death or serious bodily injury. This is known as a “flashback.”
•Be sure Burners are
Should you notice that your Burner(s) are getting hard to light or the flame is not as hot as it once was, refer to the “How to Clean your Burners” section on page 20, to remove any possible obstructions.
!WARNING
To reduce the risk of serious bodily injury or death from fire or explosion:
•During failed lighting attempts, or if the Burners go out during operation, turn Control Knobs “Off” to dissipate any accumulation of gas. Wait five minutes before repeating lighting procedure.
•Light each burner from the left before lighting the next burning to prevent gas from accumulating.
1.IMPORTANT: Make sure Control Knobs are turned “Off.” (Fig. 7)
2.Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 8)
Control Knob in | Control Knob in High position | Turn LP Gas |
Cylinder valve | ||
Off position | (large flame symbol) | counterclockwise |
|
| Fig. 8 |
Fig. 7
Fig. 9
Left Main Burner
Control Knob
Igniter Button
3.Push Burner Control Knob in on Control Panel and turn counterclockwise to the High position. (Figs. 7 and 9)
