5.Use a pipe cleaner to clear insect nests from the inlet hole of Burner (Fig. 15)

6.Open up the Burner holes (Fig. 15) with a small nail or wire. Use a non-metal- lic brush to remove food particles and corrosion from the Burner surfaces.

21

Fig. 15

 

 

Open up

Non-metallic

Burner holes

with a small

Brush

nail or wire.

 

 

Pipe Cleaner

Fig. 16

Burner

Make sure the screw holding the electrode is tight so 3/16”gap between electrode tip and burner is maintained. If necessary, gently bend the electrode wire so there is a 3/16” gap between the wire end and the burner

3/16” gap

Electrode Wire

7.Check the Electrode mounting on each burner to see if it is loose. If so, tighten the screw holding the Electrode to maintain 3/16” gap between Electrode tip and burner.

NOTE: Before next step, you may wish to clean the rest of the grill. See Grill Body and Cart (p. 19).

8. After cleaning, refit the burners.

NOTE: When refitting the burners, be sure each burner is positioned correctly. The valves should protrude inside the Venturi ends of the burner. (Figs. 12 & 14) Replace the screws that fasten the burner flange to back wall.

9.If the grill is to be stored, wrap burners in a protective cover, such as aluminum foil, to keep insects out.

10.Check burner operation after re-assembly.

11.Replace Flavor Activators and Cooking Grids.

Bottom Body Panel Removal

The Bottom Body Panel may be removed for cleaning. First remove the Grease Pan containing the Foil Pan. Next remove the crossbrace at the bottom back of the firebox. Remove the one screw at each end and slide the Bottom Body Panel out the back of the firebox.

Page 21
Image 21
Aussie 69F6U00KS1 manual Bottom Body Panel Removal