To reduce the risk of serious bodily injury or death:
·Open Hood before lighting the grill to prevent an explosion from any gas accumulation.
·If lighting attempts fail, or the burners go out during operation, turn all control knobs “Off” to dissipate any accumulation of gas. Accidental ignition could occur. Wait five minutes before repeating lighting procedure.
·Light both left and right sides of burner to prevent gas from accumulating.
LIGHTING THE GRILL USING THE IGNITOR
1.Open the Hood.
2.Important: Make sure all control knobs are turned “Off”. (FIG. 13A)
3.Turn the LP Gas Cylinder valve open counter clockwise until it stops. (FIG. 13B)
4.Push the left control knob in and turn counter clockwise to the High flame position. (FIG. 13C & 13D)
5.Pause 4 seconds and push the ignitor button in several times to light the burner. Listen for the spark ignition and look to make sure the burner is lit. If no spark, see (FIG. 13E) and Troubleshooting Section.
6.From the “Off” position, push right control knob in and turn counterclockwise to the High position. Your grill has a crossover ignition system that allows the burner to light each side successively. Make sure the right side of burner is lit.
7.If either side of burner fails to light, repeat Step 4.
If a burner goes out during operation, turn all knobs to the “Off” position and close the LP cylinder valve to dissipate any accumulated gas. Open hood and wait five minutes before attempting to relight the grill.
If any or all burners fail to light after three or four attempts following Steps
8.After ignition, turn the control knobs to “High” for
Control Knob
in OFF
position
FIG.13A
FIG. 13B
Right Control Knob
Left Control Knob
Ignitor Button
FIG. 13C
Control Knob
in HIGH position
FIG.13D
Gas Collector
Tab
Gas Collector |
|
|
Box | Electrode | 3/16” GAP |
If no spark, pinch together or open Gas Collector Tab to adjust 3/16” gap between electrode tip and edge of Gas Collector Tab.
FIG. 13E
15
