Operation2 5
Before You Begin
Warning: Read this entire manual before you use your new stove (especially the section "Safety Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or even death.
Warning: Do not operate appliance with the glass front removed, cracked or broken. Replacement of the glass should be done by a licensed or qualified service person.
Location of Controls - See explanation below
The on/off switch and optional blower control are located on the back of the heater.
ON |
OFF |
Swing the control cover
down to access the gas control valve and pilot igniter.
ON/OFF
Switch
Optional
Blower
Control
The Pilot Flame can be found below the back log.
An instruction card for operating the fireplace is attached to the inside of the fireplace here. Replace it for easy reference.
Gas
Control
Valve
IGNITER
Pilot Igniter
| Gas Control Knob | Flame Adjust Knob |
On/Off Switch | This control is used to turn the flame on and off. | |
Optional Blower | Control This knob controls the speed of the internal convection blower that | |
| pushes heated air into the room. |
Gas Control Knob This knob controls gas to the stove and pilot. There are three positions: ON, OFF, and PILOT. The indicator line is to the left of the knob.
Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI”). The indicator line is above the knob.
Pilot Igniter | The pilot igniter is used only to start the pilot. When pressed, it sends an |
| electrical charge to the pilot assembly. This creates a blue spark directly next |
| to the pilot, igniting the pilot flame. |
?If using a remote control or thermostat, the On/Off Switch must be left "OFF". Turning the On/Off Switch "ON" will keep the stove on always.
Travis Industries | 9 3 5 0 8 1 1 5 | 4 0 5 0 1 1 3 |