Avaya 3600 Series SPECIFIC ABSORPTION RATE (SAR) INFORMATION:

SPECIFIC ABSORPTION RATE (SAR) INFORMATION:

Your wireless handheld portable telephone is a low power radio transmitter and receiver. When it is ON, it receives and

also sends out radio frequency (RF) signals. In August 1996, the Federal Communications Commissions (FCC)

adopted RF exposure guidelines with safety levels for hand-held wireless phones. Those guidelines are consistent with

the safety standards previously set by both U.S. and international standards bodies:

• ANSI C95.1 (1992) American National Standards Institute

• NCRP - Report 86 (1986) National Council on Radiation Protection and Measurements

• ICNIRP (1996) International Commission on Non-Ionizing Radiation Protection;

• DHWC - Safety Code 6 Department of Health and Welfare Canada

Those standards were developed by independent scientific organizations through periodic and thorough evaluation of

scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons,

regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known

as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.3 Tests for SAR are conducted

using standard operating positions specified by the FCC with the phone transmitting at its highest certified power level

in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level

of the phone while operating can be well below the maximum value. This is because the phone is designed to operate at

multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a

wireless base station antenna, the lower the power output. Before a phone model is available for sale to the public, it

must be tested and certified to the FCC that it does not exceed the limit established by the government-adopted

requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body)

as required by the FCC for each model. While there may be differences between the SAR levels of various phones and

at various positions, they all meet the government requirement for safe exposure. The FCC has granted an Equipment

Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RF emission

guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant

section of http://www.fcc.gov/oet/fccid after searching on FCC ID IYGSNP2400 or FCC ID IYGRNP2400. Additional

information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications Industry

Association (CTIA) web-site at http://www.wow-com.com.

The only authorized headsets that may be utilized with the SNP2400 and the RNP2400 are those obtainable from

SpectraLink or it’s reseller partners.

The measured SAR of the SNP2400 Wireless Telephone is

0.61W/kG @ 2462 MHz (head) 0.0379W/kG @ 2412 MHz (body).

The measured SAR of the RNP2400 Wireless Telephone is

0.166W/kG @ 2462 MHz (head) 0.0162W/kG @ 2412 MHz (body).

Phone Operation Normal Position: Hold the phone as you would any other telephone, with the

earpiece to your ear and speak into the microphone. The internal antenna is then positioned

properly.

3 In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram

of tissue. The standard incorporates a substantial margin of safety to give additional protection for the public and to account for any

variations in measurements.