Avaya Inc. | Desktop Charger, Dual Charger, and Quad Charger User Guide |
Initiating a call Press the Talk button and wait briefly to activate the channel before talking. You may begin talking when the display shows “Transmitting.”.
Transmitting Once a call has been initiated, hold the WT two inches from your mouth and talk into the microphone. When the Talk button is released, the 3626 WT then enters the waiting state where it monitors the channel for up to ten seconds.
Initiate subsequent transmissions by pressing the Talk button on any 3626 WT using the same channel. The user can start talking immediately. The display screen shows the current active channel..
If no transmission occurs during the
Receiving Upon receiving a PTT transmission, the phone plays the “receiving alert” sound and enters the receive state.
In this state the phone receives all conversations on the selected channel. The phone will ignore the Talk button while in the receive state. The screen shows the current active channel, the caller ID information of the current transmitter, and an indication that the phone is receiving a broadcast transmission. The caller ID is protocol specific. In most cases it is simply the extension number programmed in the phone from the
At the end of a transmission, the phone enters the waiting state where it monitors the channel for up to ten seconds and displays “Waiting” on the screen. If no other transmission occurs within ten seconds the phone reverts to idle state.
Change PTT volume Use the Up and Down buttons to raise or lower PTT volume. A separate volume is maintained for PTT calls with the current volume selection retained in memory.
Muting a PTT call To mute a current call, press the Mute soft key. This brings up a Mute
Mute only affects the current call and the phone will play subsequent PTT calls. Mute does not allow the user to use the WT’s keypad for anything else, including an OAI application.
The Mute soft key turns into an Unmute soft key while in the mute state and can be used to unmute the PTT call (the confirmation prompt is displayed first).
When the next PTT call period starts the audio is automatically unmuted.
Early termination of a In order to terminate incoming broadcasts, press the Terminate PTT call soft key and answer Yes to the confirmation prompt.
session. No other WT is affected. Only the current call is terminated for this handset. When the next PTT call period starts, the WT is again in the receive state. You may rejoin a
Users should disable the PTT feature in the
| Page 18 |
