Chapter 2: Installation | 21 |
|
|
To Connect Cascaded Receivers
NOTE: Please observe the recommended overall link cable lengths (including receiver cascade connections) in order to avoid signal degradation.
1. Attach the connector of the cascade link cable to the socket labeled LINK
OUT on the primary Emerge
2. At the other end of the cascade link cable, attach the connector to the socket labeled LINK IN on the secondary Emerge
In all cases, there should be a click when the cable is fully inserted and locked in place.
3. If necessary, repeat the above procedure
for a tertiary Emerge
4. Connect the remaining signal and power cables to the
added receivers, as discussed earlier
within this chapter.
Figure 2.20: Connecting the link output of one receiver to the link input of the next