24
J. Watching TV
1. Connect the coax cable line to the supplied Right angle
adapter. Insert the supplied Right angle adapter into the
coax input located on the bottom left side of the unit.
2. With power supplied to the system and the TV mode
selected, press TV/CATV on the remote control to
select the regular 69-channel Broadcast TV and the
125-Channel Cable TV (Standard Cable, HRC Cable,
and IRC Cable) with on-screen display.
Note: Please contact your local cable provider to verify
your cable access.
3. Press AUTO MEMORY to search and tune all channels
in TV or CATV mode. The channels with signals
detected are automatically stored.
4. Use SKIP/SEARCH to select between SKIP and
SEARCH mode. In SKIP mode, the TV only stops on
channels that are programmed into memory when the
CH +/– buttons are used. When SKIP mode is off, the
TV will stop on all active channels.
5. To erase a TV channel, press ERASE/WRITE until the
channel number displayed on the screen turns red. To
store a TV channel, press this button until the channel
number displayed on the screen turns green. The
stored channel numbers are displayed in green on the
screen while the non-stored channel numbers are in
red.