Axis Communications AXIS 211W user manual Audio Settings, Enable Audio, Audio Channels Audio mode

TCP/IP Network

Example of a network

using AXIS 211W cameras to transmit audio and video across the network.

AXIS 211W - Audio Settings

Audio Settings

The AXIS 211W can transmit audio to other clients using a connected external microphone or the internal microphone and can play audio received from other clients via connected speakers. This section describes how to configure the basic audio settings for the AXIS 211W, e.g. set the communication mode and adjust the sound levels in the microphone and speakers connected to the camera.

Note: The speakers connected to the audio output must have a built-in amplifier, e.g. Client PC

PC speakers.

Enable Audio

Check this box to enable audio in the AXIS 211W.

Audio Channels - Audio mode

Full duplex mode is simultaneous two-way audio where you can transmit and receive audio at the same time.

Half duplex mode transmits and receives audio in both directions, but only in one direction at a time. This means that you must select when to receive or transmit audio with the push-to-talk button. To

speak, press and hold the button (check that the microphone is not muted). When finished speaking, release the button and you will receive audio from the other end of the connection.

Note that the push-to-talk button is configured from AMC. It is also possible to configure the push-to-talk button so that it toggles between speaking and listening modes.

When selecting Simplex - Network Camera speaker only mode, the speaker connected to the camera will play audio, but no audio will be transmitted from the camera to other web clients. This could be used to, e.g. provide spoken instructions to a person seen in the camera. This mode requires you to use the push-to-talk button.

Simplex - Network Camera microphone only mode transmits audio only from the AXIS 211W to web clients. It will not receive audio from any other web clients. This can be used in remote monitoring, web attractions etc., to provide live audio, as well as video, of a monitored situation.

When using half duplex, the Send the sound from the active client to all other clients option transmits the audio signal from the client that is talking to all the other clients.

Audio Input

Audio from a connected microphone or a line source can be connected to the Audio in connector of the AXIS 211W. The audio source must be set to Microphone or Line depending on the connected device.

Note: To prevent unauthorized listening, the internal microphone can be disabled by inserting a plug in the Audio in connector.

The Enable microphone power option provides DC power for an external microphone. If using a small electret microphone such as a clip-on mic or a PC microphone, this option needs to be enabled.

Note: When using a high impedance dynamic microphone Enable microphone power should not be checked. To use a professional micro- phone requiring 48V phantom power, you need an external power supply and must use a balanced-unbalanced converter (audio trans- former) in between.

Set Input sensitivity to High or Low depending on the sound level in the monitored area. For example, if the AXIS 211W is installed in a noisy environment set the sensitivity to Low. When using an external microphone set the Input sensitivity to High if you are using an ordinary, unamplified microphone. Set the sensitivity to Low if the connected microphone has a built-in line amplifier.

Enable microphone power with electret microphones that have no battery. Do not use this setting with a dynamic or battery powered microphone.

Select the desired audio Encoding format G711, G726 or AAC.

18