Display controller installation
Nio® medical display systems 33
Figure 4
If you decide to use a separate VGA monitor as your boot
monitor, you must disable the BarcoMedNio’s on-board VGA
capabilities by moving the jumper to the bottom two pins.
Caution: To use multiple BarcoMed Nio controllers in a single host
with VGA enabled, you should enable VGA on only ONE of the
BarcoMed Nio display controllers and disable VGA on ALL the
other BarcoMed Nio display controllers.
Examples of PCI s lots
Although the BarcoMed Nio is a 64-bit board, it may be installed
in either a 64-bit or 32-bit PCI slot. However, installing it in a
32-bit PCI slot will result in a decrease in performance. Figure
figure 5 on page 34 illustrates the types of slots so that you can
correctly identify which one to use for the BarcoMed Nio.