8. Image Settin gs
Amessage will be displayed while the Solaris LC40 examinesthe input signal : “Detection busy”.
The image jumps to the active area within the input signal.
Viewport
Horizontal start
Width
Vertical start
Height
Total pixels
Automatic
Back
Menu8-14

8.8.4 Totalpixels setup

About total number of pixels

Enterthe total number of pixels in regard with the total number of pixels in your source. Whenthe total number of pixels is not correct
(smalldifferentiation), artifacts in the form of dark bars will be visible in the image. The more visible bars in the image, the more is
the differentiation from the correct value.
Image8-4
Totalnumber of pixels
A Image with wrong total number of pixels
B Correct adjusted image

How to set up

1. Select To tal pix els. (menu 8-15)
2. Press ENTER to activate.
As liderb ar will be displayed. The actual total pixel setting will inidcated.
3. Use the ↑or ↓to set up the total pixels.
Viewport
Horizontal start
Width
Vertical start
Height
Total pixels
Automatic
Back
Menu8-15
8.9 Phase

About Phase adjustment

When displaying computer patterns or graphics (RGB or YUV signals) which are very detailed (tilting, vertical stripes, etc. ), jitter
inpicture (mis-sampling) may occur, causing horizontal stripes in portions of the screen. When this jitter occurs, adjust ’Phase’ for
optimum image.
R5976672 SOLARIS LC40 13/01/2005 49