Barco LC40 Different steps to create a viewport.

8. Image Settings
The Viewportm enu will be displayed. (menu 8-9)
Image Settings
Aspect ratio
Brightness
Contrast
(Color) Saturation
Tint
Sharpness
Viewport
Phase
Back
Menu8-8
Viewport
Horizontal start
Width
Vertical start
Height
Total pixels
Automatic
Back
Menu8-9
Different steps to create a viewport.
Image8-2
Creationof a viewport, viewson the screen while ad justing
A Input signal
B Desired image on the screen (viewport)
C Horizontalstart position
D Verticalstart position
E Set up of viewport width
F Set up of viewport height
Viewportcreation only works correctly when the totalpixels andtotal lines settin gs in theview port menu are
moreor less co rrect: The other settings (Horizontal start, horizontal size, vertical start, vertical size) depend
onthese two settings. The software does not allow ’horizontal start’ + ’horizontal size’ to be larger than ’total
pixels’. So, if the menu does not allow you to shift the image far enough, or set the image wide enough, it is
verylikely that the total amount of pixels is set too low. The same goes for the vertical parameters.
46 R5976672 SOLARIS LC40 13/01/2005