8. Image Settings
2. Press ENTER to activate.
As liderbar w illbe displayed. The actual viewport setting will indicated.
3. Use the ↑or ↓to set up the height of the viewport.
Whenset up the height of viewport, the image will be rescaled to the height of the LCD panel, see image 8-2 pa rtF.
Viewport
Horizontal start
Width
Vertical start
Height
Total pixels
Automatic
Back
Menu8-13
8.8.3 Automatic Viewport functionAbout the Automatic function
Whenthe automatic viewport function is selected, the reproduced image returns to the active are a of the input signal.
Image8-3
Viewportautomatic
A Actual viewport image
B Automatic viewport to active area
Automaticviewport detection only works correctly w hen the total pixels and total lines settings in the viewport
menuare more or less correct: Theother settings (Horizontal start, horizontal size, vertical start, vertical size)
depend on these two settings. The software does not allow ’horizon tal start’ + ’horizontal size’ to be larger
than’total pixels’. Thesame goes for the vertical parameters. So in the rare case the input source causes the
wrongfile to be selected, and that file happens to have a m uch too low setting for either of the two values ’total
pixels’or ’total lines’ , the automatic viewport function will not function correctly, because it will be limited to
the range in the ’total pixels’ and ’total lines’ values.
Steps to be taken
1. Select Automatic. (menu 8-14)
2. Press ENTER to activate.
48 R5976672 SOLARISLC40 13/01/2005