INSTALLATION SET UP
After scan inversion, close the chassis and close the top cover. Reconnect the power cord to the wall outlet.
Note
Switching over from floor to ceiling or vice versa requires a complete readjustment of picture geometry and convergence.
Check of the correct connector position
Note : this check procedure can only be done after power (mains) connection. So, first continue with the projector set up and the connections and then return to this checking procedure.
Switch on the BARCOVISION 708 MULTIMEDIA and press ADJUST to start up the adjustment mode. Select with the control disc 'Service' and press ENTER. The service menu will be displayed. Select 'PROJECTOR SET UP' and press ENTER. Select 'IDENTIFICATION' and press ENTER. On this screen, information is given about the projectors configuration.
Configuration when leaving the factory : ceiling/front configuration.
Follow next procedure to check the configuration :
- switch on the projector. |
|
| |
- the projector starts up on the last | ADJUSTMENT MODE | ||
selected source. | Select a path from below : | ||
- press the ADJUST key. | |||
GUIDED | |||
- highlight 'service' with the control | |||
RANDOM ACCESS | |||
disc and press ENTER. | INSTALLATION | ||
| |||
| SERVICE | ||
| IRIS |
| |
| Source 1 | ||
| Select with | or | |
| then <ENTER> | ||
| <EXIT> to | return. | |
The 'service mode menu' will be dis- played
-select with the control disc 'Projector set up' and press ENTER.
SERVICE MODE
PROJECTOR SETUP MEMORY MANAGEMENT COMMON SETTINGS
I²C DIAGNOSTICS
Select with 
or 
then <ENTER> <EXIT> to return.
INSTALLATION SET UP
5975069ABARCOVISION708200498 |
| |
|
