INSTALLATION ADJUSTMENTS
Optical lens focusing
The optical focusing procedure is performed separately for each lens. The appropriate CRT will be switched on as the user proceeds through the optical focusing adjustment se- quence.
Each lens has two focus adjustment points, one at the rear of the lens and one at the front. The center of the projected image is focused by loos- ening the wing nut at the rear end of the lens and rotating the lens barrel until the center of the image is clearly focused. The corners of the pro- jected image are focused by loosen- ing the wing nut at the front end of the lens and rotating the lens barrel until the corners of the image are clearly focused. Repetition of these adjustments may be necessary to optimize optical focusing.
Press ENTER key to continue.
OPTICAL LENS FOCUSING
1.LOOSEN THE NUT ON THE REAR OF THE XXXX LENS, ROTATE THE LENS BARREL TO FOCUS THE CENTER OF THE IMAGE,
THEN TIGHTEN THE NUT
2.LOOSEN THE NUT ON THE FRONT OF THE XXXX LENS AND ROTATE THE FRONT SECTION OF THE LENS TO FOCUS THE CORNERS OF THE IMAGE, THEN TIGHTEN THE NUT.
<ENTER> to continue <EXIT> to return
ENTER continues to Raster centering. EXIT returns to scheimpfug adjustment ADJUST returns to operational mode.
INSTALLATION ADJUSTMENTS
&HQWHU IRFXVLQJ
&RUQHU
IRFXVLQJ
XXXX = respectively red, green and blue.
| 5975069ABARCOVISION708200498 | |
|
