BURNER FLAME CHECK

Adjust flame height using brass valves. Rotate air control shutter

BURNER

ORANGE

to achieve mostly blue flame. The air control shutter mounted on the front of burner helps to control the amount of air that mixes with the LP gas. A blue flame with little or no yellow flame indicates a proper air/gas mixture and provides the best heat. Adjust the air control shutter until the desired flame is achieved.

FLAME BLUE

CORRECT INCORRECT

NOTE: Make sure the male fitting on hose is screwed into the burner/air shutter and tightened securely. Do not over-tighten as the air shutter needs to move freely in order to adjust air intake. Check the attachment for proper connection everytime propane tank is connected to cooker.

HINT: Before lighting, turn air control shutter on the burner to an almost closed position. This increases the gas portion of the air/gas mixture and makes the burner easier to light. After lighting, turn air control shutter to an open position to achieve a better flame.

When lighting for the first time, you will smell paint burning at the top of the cooker for a few minutes...

This is normal.

If burner flame does NOT ignite immediately, or is accidentally extinguished, turn LP Gas Cylinder Valve clockwise to OFF. Then turn regulator brass valves clockwise to OFF position.

Wait 5 minutes for gas to evacuate before re-lighting, then repeat steps 1 - 6 to re-light. Always use caution when re-lighting as cooker frame and cooking vessel will be hot.

If the burner does not light within the first few attempts, there is a problem with the gas supply.

Turn off the gas at the cylinder and regulator. DO NOT attempt to operate the cooker until the problem is found and corrected. Refer to Troubleshooting on Pages 26 - 27.

HOW TO REIGNITE BURNER

Follow steps 1-6 on previous page, to reignite burner. Use caution when re-lighting the burner, as hot oil from cooking vessel may have splattered and run down the sides of the unit creating

a slick surface. Use caution not to bump the cooker or cooking vessel when re-lighting the burner.

TURNING OFF COOKER AND DISCONNECTING HOSE

NOTE: Turn off LP gas cylinder valve first to prevent gas from being left in the regulator hose system under pressure.

1.Turn OFF the LP gas cylinder valve clockwise until it stops.

2.Turn brass valves to the OFF position, clockwise until they stop.

3.To disconnect Regulator Hose Assembly, turn the large coupling nut counter-clockwise by hand.

 

 

 

 

 

E

 

 

 

 

 

S

O

 

 

 

W

I

 

 

K

 

F

 

 

 

 

F

C

 

 

 

 

- CLO

 

 

 

1

Turn OFF

LP Cylinder.

Close Valve Fully

O

 

 

 

S

E

F

 

 

 

 

 

 

I

 

F

-

 

W

 

 

 

K

 

 

 

 

CLOC

 

 

 

2

Turn OFF Regulator. Close Valve Fully

3

Disconnect Regulator

Turn COUNTER-CLOCKWISE to Disconnect

The LP gas cylinder valve should always be in the OFF or closed position when the cooker is not in use.

17

Page 19
Image 19
Bayou Classic DB375, DB250 owner manual HOW to Reignite Burner, Turning OFF Cooker and Disconnecting Hose