To the Owner:
Thank you for purchasing a Beckett burner for use with your heating appliance. Please pay attention to the Safety Warnings contained within this instruction manual. Keep this manual for your records and provide it to your qualified service agency for use in professionally setting up and maintaining your oil burner.
Your Beckett burner will provide years of efficient operation if it is professionally installed and maintained by a qualified service technician. If at any time the burner does not appear to be operating properly,
immediately contact your qualified
service agency for consultation.
We recommend annual inspection/ service of your oil heating system by a qualified service agency.
Daily – Check the room in which your burner/appliance is installed. Make sure:
yAir ventilation openings are clean and unobstructed
yNothing is blocking burner inlet air openings
yNo combustible materials are stored near the heating appliance
yThere are no signs of oil or water leaking around the burner or appliance
Weekly
yCheck your oil tank level. Always keep your oil tank full, especially during the summer, in order to prevent condensation of moisture on the inside surface of the tank.
Contents |
| |
General Information | 4 | |
Hazard Definitions | 4 | |
▼ | Remainder of manual to be used ONLY BY | ▼ |
| QUALIFIED SERVICE TECHNICIANS |
|
Inspect/Prepare Installation Site | 5 | |
Clearances to Burner and Appliance | 5 | |
Combustion Chamber and Burner Retrofitting | 5 | |
Inspect Chimney or Direct Vent System | 5 | |
Combustion Air Supply Information | 7 | |
Direct/Sidewall Venting Application | 7 | |
Prepare the Burner | 8 | |
General | 8 | |
Installing the Oil Tank and Supply System | 8 | |
Fuel Line Valves and Filter | 8 | |
Mount Burner on Appliance | 9 | |
Connect Fuel Lines | 9 | |
Wire Burner | 9 | |
Burner packaged with appliance | 9 | |
Burner installed at jobsite | 9 | |
Special wiring required with covered burners | 9 | |
Burner Controls | 10 | |
GeniSys Model 7505 Control | 10 | |
Features | 10 | |
Wiring | 10 | |
Reset Button Operation | 12 | |
Wire Burner | 14 | |
Start Up Burner and Set Combustion | 14 | |
Set combustion with instruments | 14 | |
Perform Regular Maintenenance | 15 | |
Shutting the Burner Off | 16 | |
Removing Nozzle Line for Service | 16 | |
Nozzle Installation | 16 | |
Check/Adjust Electrodes | 17 | |
Blower Wheel Replacement | 17 | |
Replacement Parts | 19 | |
Limited Warranty Information | 20 | |
AFII Burner Manual
3
