55X32 COMPACT DIGITAL MIXER User Manual

The Scribble Strip tab allows the color, icon and name that appears in the small LCD display of a channel, bus, matrix or DCA group to be adjusted.

1.Adjust the 1st encoder to select the channel, bus, matrix, DCA group, etc. you wish to edit.

2.Adjust the 2nd encoder to set the color for the currently selected channel.

•The selected color will be shown in the LCD screen above the selected channel’s fader. For example, if DCA#5 is assigned the color red, the LCD screen above output fader #5 will illuminate in red.

3.Adjust the 3rd encoder to select the graphical icon for the channel. A large variety of clip-art is available to represent various input sources and output destinations.

4.Adjust the 4th encoder to select a name from a list of common preset names (snippets), for the currently selected channel.

5.Tap the 4th encoder to assign the currently highlighted preset text (snippet) to the channel.

6.Tap the 5th encoder to edit the channel name. An edit screen will pop up.

7.Adjust the 4th encoder to shift the cursor position.

8.Tap the 4th encoder to issue a “backspace” command, deleting the currently highlighted character.

9.Adjust the 5th encoder to select a letter, number, or symbol to enter into the channel’s name field.

10.Tap the 5th encoder to insert the currently highlighted letter, number, or symbol into the channel’s name field.

11.Adjust the 6th encoder to select whether the text entry choices offer capitals, normal characters, or numbers and symbols.

12.Tap the 6th encoder to exit the editing page, and save the current parameters to the channel.

7.5.6 Setup Screen: Preamps Tab

The Preamps tab allows the digital trim to be adjusted for all local and AES50 channels.

1.Adjust the 1st encoder to select a block of 8 channels.

2.Adjust encoders 2-5 to set the preamp gain for the top or bottom row of inputs.

3.Tap encoders 2-5 to toggle phantom power on and off.

Note - Use the Layer Up and Down buttons to select the top or bottom row of inputs for editing.

7.5.7 Setup Screen: Card Tab

The Card tab allows selection and configuration of the X-USB card. Note that if no card is installed, this tab is not accessible. Specific routing for the card can be adjusted on the Routing: Home and Card Out tabs.

1.Adjust the 2nd encoder to select the configuration that best suits your application. See the USB Interface Operation chapter for more details. Options include:

•32 in/32 out

•16 in/16 out

•32 in/8 out

•8 in/32 out

•8 in/8 out

•2 in/2 out

2.Tap the 2nd encoder to confirm your selection.