Behringer X32 MIDI RX/TX > REMOTE, MIDI CC (raw), MIDI CC (raw), MIDI CC (raw), Mackie Control, HU

71X32 COMPACT DIGITAL MIXER User Manual

MIDI RX/TX > REMOTE

Enables a specific form of bi-directional MIDI communication for remote controlling a computer DAW application using control elements of the X32 console. REMOTE can be used in 3 modes, Mackie Control, HUI and raw MIDI CC (raw) controllers (see Setup/remote)

•MIDI CC (raw) selected and Remote is enabled+active, the group section buttons

> will emit the following messages on Channel 01:

Group 1-8 SELECT = Note 64-71, on(127)/off(0), push non-latching Group 1-8 SOLO = CC 32-39, on(127)/off(0), toggle latching Group 1-8 MUTE = CC 40-47, on(127)/off(0), toggle latching Sends On Fader = CC 48, on(127)/off(0), toggle latching

Group DCA 1-8 = Note 72, on(127)/off(0), push non-latching BUS 1-8 = Note 73, on(127)/off(0), push non-latching

BUS 9-16 = Note 74, on(127)/off(0), push non-latching MTX 1-6 = Note 75, on(127)/off(0), push non-latching

MIDI CC (raw) selected and Remote is enabled+active, then group section faders 1-8

>will emit CC #0-7, value 0…127 messages on Channel 01

•HUI selected and Remote is enabled+active, then the group fader section and buttons will emulate the HUI control surface protocol, i.e. for ProTools.

>SELECT/SOLO 1-8 buttons will select or solo the corresponding track in the DAW, in banks of 8 tracks

>Sends On Fader = enables touch-writing a fader automation on selected track, track automation mode in DAW must be ‘touch’, (latching)

>use the layer buttons to determine the function assigned to the MUTE 1-8 buttons, the LED displays indicate that function

-Group DCA 1-8 = allows to move the bank selection of tracks in a DAW, (push non-latching)

-BUS 1-8 = allows to set DAW tracks to ‘Record Ready’, (push non-latching)

-BUS 9-16 = enables using the MUTE buttons for track mute in the DAW, (latching)

-MTX 1-6 = enables using the MUTE buttons for transport controls in the DAW, (latching)

•MACKIE CTRL selected and Remote is enabled+active, then the group fader section and buttons will emulate the Mackie Control Universal protocol

> SELECT/SOLO 1-8 buttons will select or solo the corresponding track in the DAW, in banks of 8 tracks

> Sends On Fader = enables touch-writing a fader automation on selected track, track automation mode in DAW must be ‘touch’ or ‘latch’, (latching) > use the layer buttons to determine the function assigned to the MUTE 1-8 buttons, the LED displays indicate that function

-Group DCA 1-8 = allows to move the bank selection of tracks in a DAW, (push non-latching)

-BUS 1-8 = allows to set DAW tracks to ‘Record Ready’, (push non-latching)

-BUS 9-16 = enables using the MUTE buttons for track mute in the

DAW, (latching)

-MTX 1-6 = enables using the MUTE buttons for transport controls in the DAW, (latching)w