Important warning
-Should you encounter a problem that has previously never occured after you start using these detergents, contact the detergent manufacturer directly. You
will find contact details on the packet.
If you stop using this kind of detergent:
-Ensure that the salt and rinse aid dispensers are full.
-Put the water hardness setting at the highest level and run a wash cycle with the appliance empty.
-After washing while empty, return the water hardness setting to the correct level for your mains water hardness shown in the manual.
-Put the rinse aid setting at the correct level.
If the dishwasher is considerably full and the dishes
are relatively dirty, fill the main container (A) up to
25cm³ level. If the dishwasher is not quite full and
the dishes are only slightly soiled, fill
the main container
(A) only up to 15cm³ level.
If your dishes are
kept unwashed for
a long time and the food particles
are stuck on the dishes also fill the
small container (B) u p t o 5 c m ³ .
Depending on the
degree of soiling and the water
hardness in your area it may be necessary to add more detergent.
Powder and gel detergents are poured into the
dispenser.
If you are using tablet detergent read the
manufacturer’s recommendations on the packaging
in order to determine where the tablets should be
placed inside the dishwasher (detergent dispenser, cutlery basket, etc.)
After you put in the detergent, shut the container lid (D) and ensure you hear the clicking sound. During the wash programme the detergent will dispense automatically and the lid (D) will remain open when the programme finishes.
Do not use detergent when using the
Use only rinse aid intended for household dishwashers.
The rinse aid is specially formulated to be used in the dishwashers for the prevention of watermarks and scale on dishes and to increase the efficiency of the washing and drying processes. Therefore, make sure that there is adequate
amount of rinse aid in
the rinse aid dispenser
of your machine. can adjust the amount
of rinse aid used during the wash programme by turning the rinse aid dispenser regulator (C).
(C)may be set between levels 1 and 6 (6 being the maximum amount of rinse aid usage). Your machine is
factory to level 4. According to the finish and drying results obtained, adjust the dose of rinse aid by means of the six position selector. (Position 1: minimum dose, Position
6: maximum dose.)
Gradually increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes.
Open the rinse aid dispenser lid by pressing the button
as shown in the diagram.
Fill up with rinse aid until the container is full to level of ’max’ mark .
Put the lid (E) on and ensure you hear the clicking
sound.
Remember to CLOSE the lid after every refill.
Make sure you clean any rinse aid that you might have spilled.
Dark = sufficient rinse aid | Light = add rinse aid |
13
