Using Your Dishwasher
·Turn on the water tap and plug in the appliance.
·Open the door and load the dishwasher. Check that both the upper and lower sprayer arms can move freely.
·Add the appropriate amount of detergent to the dispenser and close the door.
·Use the On/Off button to switch the appliance on.
·Check the control indicators for salt (17) and rinse aid (15). Refill salt and rinse aid if required.
·Use the programme selection button to select your washing programme as shown in the programme table (see page 22).
- The duration of the selected programme is shown in the display (12).
- If required, you can use the option buttons (10&2) to adjust the washing programme to suit your needs.
·Use the Start/Stop button to start the programme.
Warning !
Avoid opening the door during the washing process. This interrupts the washing process, and hot steam will escape. Close the door to continue the programme.
·When the washing programme has finished, the corresponding symbol lights up; the remaining time indicator now shows 00:00.
·Shut off the appliance by pressing the On/Off button
·Close the water tap and unplug the device from the mains.
·Allow your dishes to cool for 15 minutes with the door open. Unload the dishes, starting with the lower basket.
Programme selection
You can select the program you like after turning on the machine by pressing On / Off button. Select the program you would like to operate by pressing program selection button. You can follow up the program you are in from the program display on the screen. The program number on the display will increase one by one as you keep on pressing the program selection button. The selected washing program will start operating when you press Start / Pause / Cancel button. As the program starts up, the estimated remaining time until the end of the program will be shown by the time display. Total time of program may be different from the one displayed initially as the time of washing will vary depending on the room temperature, supplied water temperature, reprocessing the water softening unit (regeneration) and amount of the dishes.
Adding Function to the Program:
You can run program by activating Half Load 
, Extra Drying 
and Time Delay 
functions by using the function buttons. To add a function to the program:
1.Select a program by pressing Program selection button.
2.Press the button of the function you want to activate and be sure that the lamp of the relevant function display lights on the screen.
3.You can start your program by pressing Start / Pause / Cancel button.
Operation of the machine will not change even if the extra drying function is selected in the
Time Delay
You may delay the startup time of the program you select up to 24 hours. Delay cannot be set after the program is started. To adjust the delay time, the selected program must not be started.
When any of the time delay buttons is pressed, Time Delay Active Indicator 
starts flashing. Set the desired time by pressing (+) or
/Cancel button after completion of time setting. The Time Delay Active Indicator will light on the screen throughout the countdown for the delay, meanwhile the remaining time will be shown on the time display. The program will automatically start as soon as the countdown comes to an end.
If there is any economical power tariff in your area fixed for certain periods of time, you may benefit from the Time Delay feature.
19
