User’s Manual 17 / EN
Installation

3.5 Connecting water supply

C
NOTE
¾The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 1
MPa). It is necessary to have 10 – 80 litres of water flowing from the fully open tap in
one minute to have your machine run smoothly. Attach a pressure reducing valve if water
pressure is higher.
¾If you are going to use the double water-inlet product as a single (cold) water-inlet unit,
you must install the supplied blind stopper to the hot water valve before operating the
product. (Applies for the products supplied with a blind stopper group.)
A
CAUTION
¾Models with a single water inlet should not be connected to the hot water
tap. In such a case the laundry will get damaged or the product will switch
to protection mode and will not operate.
¾Do not use old or used water inlet hoses on the new product. It may cause
stains on your laundry.
1 2 3
1 Connect the special hoses supplied with the product to the water inlets on the product. Red hose (left)
(max.90ºC)isforhotwaterinlet,bluehose(right)(max.25ºC)isforcoldwaterinlet.
ACAUTION
¾Ensure that the cold and hot water connections are made correctly when
installing the product. Otherwise, your laundry will come out hot at the
end of the washing process and may damage your machine.
2 Tighten all hose nuts by hand. Never use a tool when tightening the nuts.
3 Open the taps completely after making the hose connection to check for water leaks at the connection
points. If any leaks occur, turn off the tap and remove the nut. Retighten the nut carefully after checking
the seal. To prevent possible water leakages, keep the taps closed when the machine is not in use.