Installing and Setting Up the Card | Belkin F5D7001 instruction

Installing and Setting Up the Card

3.3Windows will ask you where the drivers are located. Make no changes and click “Next” until you see the screen that asks you to click “Finish” to complete the installation.

Note: Specific screens differ depending upon which version of the Windows OS you

are using.

3.4When the installation is complete, a small Signal Indicator icon (red) in your system tray (bottom right corner of most screens) will appear. Double-click the Signal Indicator icon to bring up the “Wireless Network” screen.

3.5Select the network you want to connect to under “Available networks” and click “Connect”.

14

Image 16

Belkin F5D7001 user manual Installing and Setting Up the Card

Contents

High-Speed Mode Wireless G Desktop Network Card Table of Contents Introduction Introduction Cordless Phone Placement Avoid Obstacles and Interference Choose the quietest channel for your wireless network Secure connections, VPNs, and AOL Introduction Product Features Overview Connection rates of up to 54Mbps or 125Mbps* using HSM Difficult-to-wire environmentsCompatibility with 802.11b products Frequently changing environments Card Connector Detachable Antenna Product SpecificationsActivity LED green Link LED orange Package Contents System Requirements Installing and Setting Up the Card Install the Software Insert the Card into the Computer Installing and Setting Up the Card Let Windows Finish the Installation Installing and Setting Up the Card Installation is now complete Click on the Wireless Networks tab Enable Radio Setting Wireless Network PreferencesAvailable Networks Preferred Networks Add, RemoveSystem Tray Icon Properties Access Point Infrastructure Networks Only Any Available Network Access Point PreferredComputer-to-Computer Ad-Hoc Networks Only Securing your Wi-FiNetwork Bit WEP WEP Wired Equivalent PrivacyEncryption Keys WPA Wi-Fi Protected Access C3030FAF0F4BB2C3D44BC3D4E7 = 128-bit WEP key Using a Hexadecimal Key Changing the Wireless Security Settings WEP Setup Bit WEP Encryption C3030FAF0F4BB2C3D44BC3D4E7 = 128-bit WEP key WPA-PSK no server WPA with server Settings Using the Belkin Wireless LAN Utility Type your WEP key in the Network key box Using the Belkin Wireless LAN Utility Using the Belkin Wireless LAN Utility Monitoring the Status of your Network Connection Signal Client IP AddressNetwork Connection Type Radio State Monitoring Data Transfer Click on the Statistics tab Finding Available Networks in your Area Performing Diagnostic Tests on your Connection Click on the Diagnostics tabControl Registers Sprom Format Version Loopback Test Interrupt TestLED Test Troubleshooting Can’t connect to the Internet wirelessly Name of your wireless network appears in Available Networks Installation CD-ROM does not start Setup Utility Power LED does not come on Card is not working Link LED is solid but cannot connect to the Internet Signal strength is poor Data transfer is sometimes slow Troubleshooting Wireless PCI Card is not Detected by Operating System Wireless Comparison What’s the difference between 802.11b, 802.11g and 802.11a? Technical Support Europe 00 800 223 55 Australia 1800 666 FCC Statement Federal Communications Commission Notice Information Belkin Corporation Limited Lifetime Product Warranty Belkin Tech Support