Manuals / Belkin / Computer Equipment / Network Card

Belkin F5D7001 user manual Installing and Setting Up the Card

Models: F5D7001

1 52

Download 52 pages 22.48 Kb

Page 14

Installing and Setting Up the Card

2.4Confirm that the Card will fit into the slot you have chosen. Keep in mind that the included antenna needs to be oriented with the top pointing up. If there are cables and other connectors in the way, try to pick the PCI slot that has the fewest obstructions to the correct positioning of the antenna.

2.5Remove the metal port cover from the back of the computer that corresponds to the PCI slot you selected. If there is a screw, place it in a safe place, as you will be using it to attach the Card to the computer later.

2.6Push the Card firmly into the PCI slot that you have chosen. Apply pressure as needed until the connector is fully seated.

2.7Now secure the Card with the screw that you previously placed in a safe place.

2.8Carefully screw the antenna onto the threaded connector on the Card. Turn the antenna until it is vertical and pointing up.

2.9Replace the computer’s cover. Now that the Card is installed, you can reconnect the power cord, and turn it back on.

12

Image 14

Belkin F5D7001 user manual Installing and Setting Up the Card

Contents

High-Speed Mode Wireless G Desktop Network Card Table of Contents Introduction Introduction Cordless Phone Placement Avoid Obstacles and InterferenceChoose the quietest channel for your wireless network Secure connections, VPNs, and AOLIntroduction Product Features OverviewCompatibility with 802.11b products Connection rates of up to 54Mbps or 125Mbps* using HSMDifficult-to-wire environments Frequently changing environmentsActivity LED green Card ConnectorDetachable Antenna Product Specifications Link LED orangePackage Contents System RequirementsInstalling and Setting Up the Card Install the SoftwareInsert the Card into the Computer Installing and Setting Up the Card Let Windows Finish the Installation Installing and Setting Up the Card Installation is now complete Available Networks Setting Wireless Network PreferencesClick on the Wireless Networks tab Enable Radio System Tray Icon Preferred NetworksAdd, Remove PropertiesComputer-to-Computer Ad-Hoc Networks Only Any Available Network Access Point PreferredAccess Point Infrastructure Networks Only Securing your Wi-FiNetwork Encryption Keys WEP Wired Equivalent PrivacyBit WEP WPA Wi-Fi Protected Access C3030FAF0F4BB2C3D44BC3D4E7 = 128-bit WEP keyUsing a Hexadecimal Key Changing the Wireless Security Settings WEP Setup Bit WEP EncryptionC3030FAF0F4BB2C3D44BC3D4E7 = 128-bit WEP key WPA-PSK no server WPA with server Settings Using the Belkin Wireless LAN Utility Type your WEP key in the Network key box Using the Belkin Wireless LAN Utility Using the Belkin Wireless LAN Utility Monitoring the Status of your Network Connection Network Connection Type SignalClient IP Address Radio StateMonitoring Data Transfer Click on the Statistics tabFinding Available Networks in your Area Control Registers Performing Diagnostic Tests on your ConnectionClick on the Diagnostics tab Sprom Format VersionLED Test Interrupt TestLoopback Test Troubleshooting Can’t connect to the Internet wirelesslyName of your wireless network appears in Available Networks Installation CD-ROM does not start Setup Utility Power LED does not come on Card is not workingLink LED is solid but cannot connect to the Internet Signal strength is poor Data transfer is sometimes slowTroubleshooting Wireless PCI Card is not Detected by Operating System Wireless Comparison What’s the difference between 802.11b, 802.11g and 802.11a?Technical Support Europe 00 800 223 55 Australia 1800 666FCC Statement Federal Communications Commission NoticeInformation Belkin Corporation Limited Lifetime Product Warranty Belkin Tech Support