Belshaw Brothers 10-Tray Programming the control panel, Function of Setting, Fan Cycle Setting

Programming the control panel

Pre-set values for bake temperatures, bake time, steam and damper may be modified at any time. Numbers in parentheses reference numbers in Figure 1-2.

To change the program values:

1.Press the up and down arrow keys (2) to select the program you wish to change.

2.Press the key next to the value you wish to change (i.e. temperature or time) (6-9). A selection indicator will flash in the right hand side of the selected window. Use the up/down arrow keys to modify the value.

3.The program can be run using these values as a temporary setting, or the setting changes can be saved. If the program changes are not saved, the settings will revert back to the original settings the next time the program is selected.

4.To save the changes, press and hold the P key (5).

All displayed values will flash and the controller will beep to indicate the program has been saved. After the controller has beeped, release the P key.

Note: Programs cannot be saved during a bake cycle.

Function of Setting

Key 6: Vent Time. This is the number of minutes at which the vent will wait to open during the bake cycle.

Note: This time cannot exceed the bake time.

Key 7: Steam Time. This is the amount of time the steam will inject at the beginning of the bake. Time can be set from 1-15 seconds.

Note: The oven must be above 257“ F (125“ C) before the steam will inject.

Key 8: Bake Time. This is the amount of time the product will bake. Time can be set from 1-99 minutes.

Key 9: Temperature. This is the temperature at which the oven will bake the product. Temperature can be set from 122“ F to 482“ F (50“ C to 250“ C).

Fan Cycle Setting

1.Press the P key (5) and the Stop key (4) at the same time, and hold for five seconds. The display will show “FAN 00” if the fan is currently disabled or “FAN 01” if the fan is currently enabled.

2.Use the up/down arrow keys to select the fan setting.

Note: The default setting for the fan is "fan cycling disabled."

Note: In a 4-tray oven, the fan is only functional in an oven wired for 3-phase. If activated in a 1-phase oven, the fan will automatically stop.

Belshaw Bros., Inc. š 1750 22nd Ave. S. š Seattle, WA 98144 š Phone 206-322-5474 š Fax 206-322- 5425

BX Classic Oven MN-1876EN 3