Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, besides adjusting the height of the projector, you will need to manually correct it following ONE of these steps.
• Press | / | on the control panel of the |
| |
projector or remote control to display the |
| |||
Keystone correction page. Press | to |
| ||
correct keystoning at the top of the image. |
| |||
Press | to correct keystoning at the bottom |
| ||
of the image. |
|
|
| |
• Press MENU/EXIT on the projector or |
| |||
remote control. Go to the DISPLAY > |
| |||
Keystone and adjust the values by pressing | Keystone | |||
or |
| on the projector or remote |
| |
control. |
|
|
|
|
Press |
|
|
|
|
|
|
|
|
/ . |
|
| Press | / . | ||||
|
| |||||||
MENU Back
Magnifying and searching for details on the projected picture
If you need to find the details on the projected picture, magnify the picture. Use the direction arrow keys for navigating the picture.
•Using the remote control
1.Press D. ZOOM +/- to display the Zoom bar. Press D. ZOOM + to magnify the center of the picture. Press the key repeatedly until the picture size is suitable for your need.
2.Use the directional arrows ( 
, 
, 
, 
) on the projector or remote control to navigate the picture.
3.To restore the picture to its original size, press AUTO. You can also press D. ZOOM
•Using the OSD menu
1.Press MENU/EXIT and then press 
/ 
until the DISPLAY menu is highlighted.
2.Press 
to highlight Digital Zoom and press Mode/enter. The Zoom bar displays.
The picture can only be navigated after the picture is magnified. You can further magnify the picture while searching for details.
34 Operation
