BenQ mx618st, ms616st user manual Adjusting the projected image, Adjusting the projection angle

Adjusting the projected image

Adjusting the projection angle

The projector is equipped with 1 quick-release adjuster foot and 1 rear adjuster foot. These adjusters change the image height and projection angle. To adjust the projector:

1.Press the quick-release button and lift the

	front of the projector. Once the image is
	positioned where you want it, release the
	quick-release button to lock the foot in
	position.
2.	Screw the rear adjuster foot to fine-tune the	1	2
	horizontal angle.

To retract the foot, hold up the projector while
pressing the quick-release button, then slowly lower	Do not look into the lens while the
the projector. Screw the rear adjuster foot in a
	lamp is on. The strong light from the
reverse direction.
	lamp may cause damage to your eyes.

If the projector is not placed on a flat surface or the screen and the projector are not perpendicular to each other, the projected image becomes trapezoidal. To correct this situation, see "Correcting keystone" on page 19 for details.

Be careful when you press the quick- release button as it is close to the exhaust vent where hot air comes from.

Auto-adjusting the image

In some cases, you may need to optimize the picture quality. To do this, press AUTO on the projector or remote control. Within 3 seconds, the built-in Intelligent Auto Adjustment function will re-adjust the values of Frequency and Clock to provide the best picture quality.

The current source information will be displayed in the corner of the screen for 3 seconds.

This function is only available when PC signal (analog RGB) is selected.

Fine-tuning the image size and clarity

1.	Adjust the projected image to the	2.	Sharpen the image by rotating the
	size that you need using the zoom		focus ring.
	ring.

18 Operation