Connecting Video or S-Video devices

The following standards are supported in the digital TV function:

•	480i	•	480p
•	576i	•	576p
•	720p (50/ 60 Hz)	•	1080i (50/ 60 Hz)

Connecting Video or S-Video devices

S-Video or Video devices

Audio cable	D-
	SUB
	SUB/COMPD- IN

AUDIO

S-VIDEO VIDEO

AC-

Video cable

S-Video cable

If the selected video image is not displayed after the projector is turned on and the correct video source has been selected, check that the video source is turned on and operating correctly. Also check that the signal cables have been connected correctly.

Connecting display devices

If you want to monitor your presentation close-up on a monitor as well as on the screen, you can connect the RGB signal output port on the projector to an external monitor with a VGA cable.

VGA cable

D SUB-

OUT

SUB/COMPD-

AUDIO

S-VIDEO VIDEO

AC-INLET

16 Connection

Page 20

Image 20

BenQ PB6240 user manual Connecting Video or S-Video devices, Connecting display devices, Video or Video devices

Contents

Welcome Copyright Disclaimer Table of contents Projector specifications Iv Table of contents Important safety instructions Important safety instructionsBut could fail if power cuts or surges Safety Instructions Locations near fire alarms Locations with an ambient temperatureUsing the unit when it is not fully Bedding or any other soft surface Safety Instructions Introduction Projector featuresIntroduction Shipping contents Optional accessories Projector exterior viewFront / upper side Rear side Bottom side Connector panelFront adjuster foot Lamp cover Rear adjuster foot Controls and functions External control panel Your Microsoft PowerPoint Sequentially select the input signalRemote Ccontrol Backwards Remote control effective range Installing or replacing the remote control battery Positioning your projector Choosing a location Obtaining a preferred projected image size Focus ring Zoom ring Positioning your projector Screen size chart 43 aspect ratio Screen size chart 169 aspect ratio Connecting a computer Connecting Component Video devicesConnection VGA cable Audio cable USB cable Video or Video devices Connecting Video or S-Video devicesConnecting display devices Utilizing the password function To set a passwordOperation Start up To change the password If you forget the passwordTo enter the password recall procedure Adjusting the image Adjusting the heightAuto-adjusting the image Fine-tuning the image size and clarity Correcting keystone Selecting a picture modePresentation default SRGB/Photo Gaming Video Switiching input signal Hiding the imageSlide operation Freezing the image Disconnect the power cord from the wall socket Shutdown Menu operation Menu system Using the menus Picture menu ApplicationMode Color Temp Brightness ContrastColor Tint Pro-Picture menu Setting menu Advance menu Information menu Maintenance Care of the projector Lamp information Replacing the lamp Do not turn the power on with the lamp cover removed Temperature information Indicators For assistance Projector needs 110 seconds to cool down. OrPlease contact your dealer for assistance Service information Accessories included in the standard packageOptional accessories not included in the standard package Ordering parts or getting information Make sure that it is switched on TroubleshootingPlug the power cord into the AC inlet on Specifications Projector specifications Timing chart Supported timing for PC inputSupported timing for Component-YPbPrinput Supported timing for Video and S-Video inputs Dimensions Unit mm Specifications Warranty WarrantyLimited Warranty Regulation Statements FCC statementEEC statement MIC statement