Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, besides adjusting the height of the projector, you will need to manually correct it following ONE of these steps.
1. Press 3 Left/ Right 4 (hot key) on the control panel of the projector to display the status bar labelled Keystone. Press 3 Left to correct keystoning at the top of the image. Press Right 4 to correct keystoning at the bottom of the image.
2. Press 
/ 
on the remote control to display
the status bar labelled Keystone, then press 
to correct keystoning at the top of the image or press
to correct keystoning at the bottom of the image.
3. Press 6 Menu on the projector or Menu on the remote control. Go to | Picture |
For example,
1.Press 3 Left on the projector or
2.Press 
on the remote control or
3.Press 3 Left on the projector or 3 on the remote control when you are in Picture
Keystone |
|
| 0 | Keystone |
1.Press Right 4 on the projector or
2.Press 
on the remote control or
3.Press Right 4 on the projector or 4 on
the remote control when you are in Picture -
Keystone | 0 | Keystone |
+6
Selecting a picture mode
The projector is preset with several picture modes so that you can choose one to suit your program type. To select a operation mode that suits your need, press Mode. The picture modes available for different types of signals are shown below.
PC Signal Input
Presentation (default)
sRGB/Photo
Gaming
Video
YPbPr /
Photo (default)
Movie
Cinema
Gaming
Refer to page 25 for more information.
20 Operation
