Timing of replacing the lamp
When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and in some instances the lamp may explode.
Go to http://lamp.benq.com for a replacement lamp.
The Lamp indicator light will light up if the lamp becomes too hot. See "Indicators" on page 79 for details.
The following lamp warning displays will remind you to change the lamp.
The warning messages below are for reference only. Please follow the actual
Status | Message |
Install a new lamp for optimal performance. If the |
|
projector is normally run with Economic selected |
|
("Setting Lamp Mode as Economic" on page 74), |
|
you may continue to operate the projector until |
|
the next lamp warning appears. |
|
Press MODE/ENTER to dismiss the message. |
|
|
|
A new lamp should be fitted to avoid the |
|
inconvenience when the projector runs out of |
|
lamp time. |
|
Press MODE/ENTER to dismiss the message. |
|
|
|
It is strongly recommended that you replace the |
|
lamp at this stage. The lamp is a consumable item. |
|
The lamp brightness diminishes with use. This is |
|
normal lamp behavior. You can replace the lamp |
|
whenever you notice that the brightness level has |
|
significantly diminished. |
|
Press MODE/ENTER to dismiss the message. |
|
|
|
The lamp MUST be replaced before the projector |
|
will operate normally. |
|
Press MODE/ENTER to dismiss the message. |
|
|
|
"XXXX" shown in the above messages are numbers that vary depending on different models.
Maintenance 75
