Troubleshooting
|
|
| English |
Problem | Cause | Remedy | |
|
| Plug the power cable into the AC inlet on the |
|
| There is no power from the power | rear of the projector, and plug the power |
|
| cable into to the power outlet. If the power |
| |
| cable. |
| |
| outlet has a switch, make sure that it is |
| |
The projector does |
|
| |
| switched on. (See page 20.) |
| |
not turn on. |
|
|
|
Attempting to turn the projector on | Wait until the cooling down process has |
| |
|
| ||
| again during the cooling process. | completed. |
|
|
|
|
|
| The lamp cover is not securely | Correctly attach the lamp cover. (See page |
|
| attached. | 53.) |
|
|
|
|
|
| The video source is not turned on or | Turn the video source on and check that the |
|
| signal cable is connected correctly. (See page |
| |
| connected correctly. | 17.) |
|
|
|
| |
|
|
|
|
No picture. | The projector is not correctly | Check the connection. (See page 17.) |
|
connected to the input source device. |
| ||
|
|
|
|
| The input source has not been | Select the correct input source with the |
|
| Source keys on the remote control or |
| |
| correctly selected. |
| |
| SOURCE on the projector. (See page 21.) |
| |
|
|
| |
|
|
|
|
| The connection cables are not | Correctly connect the cables to the |
|
Image is unstable. | securely connected to the projector |
| |
appropriate terminals. (See page 17.) |
| ||
| or the signal source. |
| |
|
|
| |
|
|
|
|
| The projection lens is not correctly | Adjust the focus of the lens using the focus |
|
| focused. | ring. (See page 25.) |
|
Picture is blurred. |
|
|
|
The projector and the screen are not | Adjust the projection angle and direction as |
| |
|
| ||
| aligned properly. | well as the height of this projector if |
|
| necessary. (See page 25.) |
| |
|
|
| |
|
|
|
|
| The batteries are out of power. | Replace both of the batteries with new ones. |
|
| (See page 7.) |
| |
|
|
| |
Remote control does |
|
|
|
There is an obstacle between the | Remove the obstacle. (See page 7.) |
| |
not work correctly. | remote control and the projector. |
| |
|
| ||
|
|
|
|
| You are too far away from the | Stand within 8 meters (26.2 feet) of the |
|
| projector. | projector. (See page 7.) |
|
|
|
|
|
Additional information | 57 |
