Maintenance and care
Replace drive belt
1.Unplug the vacuum from electrical outlet.
2.With rotating floor brush removed from vacuum cleaner (steps 1 – 4 of check rotat- ing floor brush and drive belt page13), grasp old drive belt and remove from motor pulley. Discard the old drive belt.
3.Place one end of the new drive belt over motor pulley and the other end over the brush in the space between the bristles.
Note: It is important that you use only genuine BISSELL replacement parts. Generic belts may not meet the exact specifications required to keep your vacuum operating at its peak performance. The use of unbranded belts could lead to early failure of the vacuum and could void your warranty.
4.Pull the brush firmly to stretch the drive belt and place ends of brush down into slots on sides. Turn brush several times by hand to center the drive belt.
5.Reposition brush cover and screws. Tighten screws securely.
Brush reset
If something becomes lodged in the foot and the brush shuts off, turn the cleaner off and unplug from the outlet. Remove the obstruction. The brush will automatically reset when the cleaner is plugged in and turned back on.
2
3
14 w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |
