Operations
Brush Switch
The rotating brush is turned on or off using the switch located next to the power switch on the top of the tank. When the brush switch is on, the brush will start rotating when the unit is reclined. The brush should be on for most carpeted floors. You may want to turn the brush off for bare floor cleaning or other delicate surfaces.
Push the rocker switch “ON” (I) to turn the brush on, and “OFF” (O) to turn brush off.
Brush Auto Shut Off Feature
When your cleaner is in the upright position, the brush will not rotate. The brush will rotate only when the clean- er is in the reclined position and the brush switch is on.
Height Adjustments
There are seven height settings avail- able for various floor surfaces. Turn the dial on the foot of the cleaner to the desired setting.
Lowest setting – for low pile carpet or bare floors. To pick up debris it may be necessary to move up one setting.
Medium settings – for medium pile carpet.
High setting – for high pile and most shag/frieze carpet.
Note: For optimal carpet cleaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting.
If the dial is difficult to turn, tilt the cleaner back slightly to take the weight off of the foot while turning.
Some Berber carpets have a tendency to fuzz with wear. Repeated strokes in the same area may aggravate this condition. Consider setting your cleaner on a higher than normal setting for this type of carpet.
Brush Switch
Attention:
Some Frieze carpets have long delicate fibers or threads that may be damaged by the rotat- ing brush during vacuuming. It is recommended the rotating brush be turned OFF when cleaning this type of carpet.
While vacuuming, certain carpets and low humidity conditions may generate small static discharges.
The discharges are entirely harm- less and are not associated in any way with the main power supply.
7
w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |
