Assembly
The only tool you’ll need to assemble your vacuum cleaner is a Phillips head screwdriver.
Attach handle to vacuum
1.Locate the bag that contains the extension wand support, lower cord wrap, and screws. Remove the screw packet from the bag.
2.Stand the vacuum upright and from the rear of the unit, slide the base of the handle firmly into the grooves at the top of the vacuum body.
3.Ensure that the handle is firmly attached to the vacuum body. The front of the handle should be flush with the front of the vacu- um body. If there are any gaps, continue to push the handle until it is secure.
4.Remove two of the four screws from the screw packet. Insert one screw, into each of the existing holes in the handle. With a screwdriver, tighten each screw completely.
Caution:
Do not plug in your vacuum cleaner until you are familiar with all instructions and operating procedures.
2
4
Attach storage clips, tool, and vacuum hose
1.Locate the bag that contains the exten- sion wand support, lower cord wrap, and remaining two screws.
2.Attach the extension wand support to the rear of the unit. Extension wand support should be placed about half way down the vacuum body. Using one of the two remaining screws, insert one screw into the existing hole. With a screwdriver, tighten screw completely.
3.Attach the lower cord wrap to the rear of the unit. Lower cord wrap should be placed toward the bottom of the vacuum body. Using the last screw, insert screw into the existing hole. With a screwdriver, tighten completely.
4a. Attach Twist ‘n Snap™ hose by placing the |
|
tabbed end of the hose into the opening |
|
of the unit, located on the left side of the |
|
vacuum (when viewing from the back). Turn |
|
the hose to the right to lock into place. | 4a |
4b. Place the attachment end of the hose into the hole on the right side of the unit, near the wheel.
NOTE: The vacuum will not operate effectively unless the hose is firmly attached.
2
3
4b
5
w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |
