Operations
Empty dirty container
Empty the dirt container as soon as the dirt reaches the “full” line on the side of the container.
1. Unplug the vacuum from electrical outlet. | 2. |
|
2.Slide the Lock 'n Seal Lever to the “Unlock” position.
3.Grasp the handle and pull the dirt container straight out to remove from the vacuum.
4.Empty dirt into garbage container.
NOTE: Emptying the dirt container after every use will help prevent over filling and ensure that the vacuum is ready to go the next time you clean.
Cleaning the dirt container
Additional steps can be taken to clean the dirt container as necessary.
1.Ensure dirt container has been emptied.
2.While the dirt container is still out of the unit, grasp the inner cyclone screen and twist counterclockwise until the locking tabs stop the rotation. Pull down the inner cyclone screen to remove it.
3.Clean the inner cyclone with a cloth or soft brush to remove dust or debris.
4.Wipe out the inside of the upper tank and the inner cyclone with a damp cloth moistened with water or a mild cleaning solution. Let completely dry before next use.
5.If desired, the lower dirt container may be washed in warm water. Make sure it is completely dry before reassembling.
Do not put in the dishwasher.
6.To reassemble, replace the inner cyclone screen by sliding it into the upper tank and rotating clockwise until the locking tabs stop the rotation. The inner cyclone screen is labeled front and back. When properly assembled the front graphic should face out.
WARNING:
To reduce the risk of electric shock, turn power switch OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.
24
9
w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |
