Maintenance and care
Machine care continued
6.The inside of the end caps by the brush rolls can be wiped out with a clean paper
towel, or, if a more thorough cleaning is desired, the end caps can be taken off
using a Phillips head screwdriver and rinsed clean. Replace after cleaning.
7.Any loose hair or debris can be pulled from the brush rolls and thrown away. For the most thorough clean before storage, follow directions on pages 18 & 19 for removal and replacement of the brush rolls and belts.
WARNING:
To reduce the risk of fire, electric shock, or injury,turn power OFF and disconnect plug from electrical outlet before performing mainte- nance or troubleshooting.
8.To clean attachments that may have been used, remove from hose and rinse under clean, running water. Dry and replace attachment in the tool caddy. Clean the hose by suctioning clean water from the tap. Before replacing, lift end of hose and stretch out to ensure all water is cleared from hose. Refer to page 14.
9.After carpet is dry, vacuum again to remove hair and fuzz.
Small belt removal and replacement
Occasional replacement of one or
both belts may become necessary. 3. If that is needed, please follow the instructions below.
1. Turn off the machine, and unplug it from the outlet.
2. Remove both the
3. Unscrew the front nozzle and remove it. Set aside.
4. Turn the machine on its side.
IMPORTANT: cord side down.
6.
5. Remove the clear end cap by unscrew- ing the 2 black screws. Take care not to drop the screws into the unit.
2.
5.
7.
6. Remove 1 silver screw.
7. Remove pivot arm by gently lifting up.
8.Remove small brush belt.
9.Replace small brush belt, and reverse steps above.
8.
9.
18 w w w. b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |
