Troubleshooting
Built-in heater ready light does not illuminate
Possible causes
1.The heater switch is not turned ON ( I )
2.The power switch is not turned ON ( I )
Reduce Spray or No Spray
Possible causes
1.Water tank may be empty
2.Formula tank may be empty
Remedies
1.Turn the heater switch ON ( I )
2.Both switches must be ON ( I ) to activate the heater ready light
Remedies
1.Fill heavy duty bladder with hot tap water
2.Fill formula tank with BISSELL 2X Formula for cleaning
3.Tank may not be seated completely
4.Pump may have lost prime.
DirtLifter® PowerBrush does not turn
Possible causes
1.The belt is off or broken
3.Turn power OFF (0). Remove and reseat tank
4.Turn power OFF (0) and then back ON (I). Wait one minute, then depress trigger
Remedies
1.Turn power OFF ( O ) and unplug unit from outlet. Follow instructions on page 19
2. | The unit is in the upright position | 2. | Brushes only rotate when unit is reclined using the |
|
|
| detent pedal |
3. | Circuit breaker on machine may have tripped | 3. | Turn the machine OFF ( O ) and unplug from outlet. Check |
|
|
| to see if foreign object is caught in brush roll. Remove |
Cleaner not picking up solution |
| object. Plug machine in to reset circuit breaker | |
|
| ||
Possible causes | Remedies | ||
1. | ReadyTools dial may be at wrong setting | 1. | Set ReadyTools dial to either FLOOR CLEANING or TOOLS setting |
2. | Tank may not be seated properly | 2. | Pick up both the |
|
|
| reseat them so they fit snugly on the unit |
3. | Tank may not be assembled properly | 3. | Check to make sure the "lip" of the nozzle is securely |
|
|
| hooked into the groove on bottom of Tank (see page 10) |
4.Solution or
5.
6.Red float "door" in the tank may have closed as a result of bumping an object or moving machine back and forth too quickly
4.Check fluid levels in heavy duty bladder and formula tank.
5.Empty
6.Turn the machine OFF ( O ), allowing red float door to release into the open position. Turn unit back ON ( I ) to continue cleaning. Be sure your forward and backward strokes are done at a slower pace.
7. Red lint screen is dirty. | 7. Clean red lint screen (see page 17). |
Other maintenance or service not included in the manual should be performed by an authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
For any questions or concerns, BISSELL is happy to be of
service. Contact us directly at 1-800-237-7691.
20 w w w. b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |