operation

Switching On and Off - Fig. H

CAUTION: For floor use only; H do not use the unit upside down. NOTICE: When the steam mop is first

turned on the water reservoir will glow red. Once the steam mop is ready to use the water reservoir will glow blue. It takes approximately 15 seconds for the steam mop to heat up.

• To switch the appliance on, press the ON/ OFF button (1).

• To switch the appliance off, press the ON/ OFF button.

NOTICE: Never leave the steam mop in one spot on any surface for any period of time. Always place the steam mop on the resting mat (7) with the handle tube (4) in the upright position when stationary and make sure the steam mop is turned off when not in use. NOTICE: Always empty the water tank after use.

SmartSelectTM Dial

The steam mop is equipped with a SmartSelectTM dial (2) which shows various hard floor surface cleaning applications. They are used to select the correct operating mode for your particular hard floor surface.

NOTICE: Do not use on any unsealed hard floor surfaces. Additionally, on surfaces that have been treated with wax or some no wax floors, the sheen may be removed by the heat and steam action. It is always recommended to test an isolated area of the surface to be cleaned before proceeding. We also recommend that you check the use and care instructions from the floor manufacturer.

Using the SmartSelectTM dial (2), choose from one of the following applications:

The steam mop will select the correct volume

of steam required for your particular cleaning operation.

NOTICE: This unit will kill 99.9% of bacteria and germs when used in accordance with this

manual and with the micro fiber pad fitted and a continuous run time of 90 seconds.

Hints for optimum use

General USE

CAUTION: Never use the steam mop without first attaching a cleaning pad.

WARNING: It is important to monitor the water level in the water tank. To refill the water tank and continue to sanitize/ clean, see the Filling Water Tank section.

CAUTION: Never leave the steam mop in one spot on any surface for any period of time. Always place the steam mop on the resting mat (7) with the handle (4) in the upright position when stationary and make sure the steam mop is turned off when not in use.

• Always vacuum or sweep the floor before using the steam mop.

• The easiest way to use the steam mop is to tilt the handle to a 45˚ angle and clean slowly, covering a small area at a time.

Do not use chemical cleaners with your steam mop. To remove stubborn stains from vinyl or linoleum floors, you can pre-treat them with a mild detergent and some water before using the steam mop.

Steam cleaning

• Place a cleaning pad (6) on the floor with the ‘hook & loop’ side facing up.

• Raise the steam mop off the resting mat (7) and lightly press it down onto the cleaning pad.

6

Page 6
Image 6
Black & Decker BDH1720SM instruction manual Operation, Hints for optimum use, General USE, Steam cleaning