Black & Decker BDH1720SM Attaching a cleaning pad Fig. D, Removing a cleaning pad Fig. E

Attaching a cleaning pad - Fig. D
Replacement cleaning pads are available from		D
your Black & Decker dealer (cat. no. SMP20).
•	Place a micro-fiber cleaning pad (6) on the
•	floor with the ‘hook & loop’ side facing up.
	Raise the steam mop off the resting mat
	(7) and press it down onto the cleaning pad
	(6). You are now ready to steam clean and
	sanitize your floor.
NOTICE: Always place the steam mop on
the resting mat (7) with the handle (4) in the
upright position when stationary and make sure
the steam mop is turned off when not in use.

Removing a cleaning pad - Fig. E

CAUTION: Always wear suitable shoes E when changing the cleaning pad on your

steam mop. Do not wear slippers or open-toed footwear.

•Return the handle (4) to the upright position and turn the steam mop ‘OFF’.

•Place the steam mop on the resting mat and wait until it cools down. (approximately five minutes)

•Place the front of your shoe onto the cleaning pad removal tab (13) and press down firmly.

•Lift the steam mop up off the cleaning pad.

NOTICE: Always place the steam mop on the resting mat (7) with the handle (4) in the upright position when stationary and make sure the steam mop is turned off when not in use.

Filling the water tank - Fig. F & G

This Steam Mop incorporates an anti-calcium system to help prolong the life of the system.

NOTICE: The water tank is conveniently removable for easier use.

NOTICE: Fill the water tank with regular tap water.

NOTICE: In areas of very hard water, the use of de-ionized water is recommended.

WARNING: Do not overfill the tank. Only fill to bottom of hole with water tank in vertical position.

• Ensure that the appliance is switched off and the power cord is disconnected from the power supply.

• Place the steam mop on the resting mat (7) with the handle (4) in the upright position.

• Remove the water tank (3) by pulling it upwards.

• Open the filler cap (14) by lifting it up.

• Fill the water tank (3) with water to the bottom of the hole with tank in vertical position.

• Close the filler cap (14).

• Re-install the water tank onto the steam mop body (11) and ensure it is firmly seated.

NOTICE: Always empty the water tank after use.

F

G

5