Black & Decker BDH1760SM To access the Lift Reach Head, To re-fit the Lift and Reach Head

The Lift and Reach Head - Fig. G G

This Steam Mop incorporates a built in Lift

and Reach Head which enables you to access

tight corners and narrow gaps. CAUTION: Always wear suitable shoes

when accessing the Lift and Reach Head on your steam mop. Do not wear slippers or

open-toed footwear.

To access the Lift and

Reach Head:

• Return the handle to the upright position and turn the steam mop ‘OFF’.

• Place the steam mop on the resting mat and wait until it cools down. (approximately five minutes)

• Place the front of your shoe onto the steam head removal tab (15) and press down gently.

• Lift the Lift and Reach Head up off the steam head (5).

• Place the Lift and Reach Head cleaning pad (9) on the floor with the ‘hook & loop’ side facing up.

• Raise the Lift and Reach Head off the resting mat (7) and press it down onto the cleaning pad (9). You are now ready to steam clean and sanitize your floor.

To re-fit the Lift and Reach Head:

• Return the handle tube (4) to the upright position and turn the steam mop ‘OFF’.

• Place the steam mop on the resting mat and wait until it cools down. (approximately five minutes)

• Place the front of your shoe onto the Lift and Reach Head cleaning pad removal tab and press down firmly.

• Lift the Lift and Reach Head (16) up off the cleaning pad.

• Place the tip of the Lift and Reach Head into the steam head (5) and push downward. Ensure it is locked into place by gently pulling upwards on the handle.

NOTICE: Always place the steam mop on the resting mat (7) with the handle tube (4) in the upright position when stationary and make sure the steam mop is turned off when not in use.

Filling the water tank - Fig. H & I

This Steam Mop incorporates an anti-calcium system to help prolong the life of the system.

NOTICE: The water tank is conveniently removable for easier use.

NOTICE: Fill the water tank with regular tap water.

NOTICE: In areas of very hard water, the use of de-ionized water is recommended.

WARNING: Do not overfill the tank. Only fill to bottom of hole with water tank in vertical position.

• Ensure that the appliance is switched off and the power cord is disconnected from the power supply.

• Place the steam mop on the resting mat (7) with the handle tube (4) in the upright position.

• Remove the water tank (3) by pulling it upwards.

• Open the filler cap (18) by lifting it up.

• Fill the water tank (3) with water to the bottom of the hole with tank in vertical position.

• Close the filler cap.

• Re-install the water tank onto the steam mop body (11) and ensure it is firmly seated.

NOTICE: Always empty the water tank after use.

H

I

6