| operation | |
Switching On and Off - Fig. J | J | |
| CAUTION: For floor use only; |
|
do not use the unit upside down. |
| |
NOTICE: When the steam mop is first |
| |
turned on the water reservoir will glow red. |
| |
Once the steam mop is ready to use the water |
| |
reservoir will glow blue. It takes approximately |
| |
15 seconds for the steam mop to heat up. |
| |
• | To switch the appliance on, press the ON/ |
|
• | OFF button (1). |
|
To switch the appliance off, press the ON/ |
| |
| OFF button. |
|
NOTICE: Never leave the steam mop in one spot on any surface for any period of time. | ||
Always place the steam mop on the resting mat (7) with the handle tube (4) in the upright | ||
position when stationary and make sure the steam mop is turned off when not in use. | ||
NOTICE: Always empty the water tank after use. | ||
SmartSelectTM Dial - Fig. K | K | |
The steam mop is equipped with a | ||
SmartSelectTM dial (20) which shows various |
| |
hard floor surface cleaning applications. |
| |
A Light will glow next to the selected |
| |
application. To change the application, press | 20 | |
and release the SmartSelectTM button (2) | ||
repeatedly until the light glows next to the |
| |
correct operating mode for your particular |
| |
hard floor surface. |
| |
NOTICE: Do not use on any unsealed hard floor surfaces. Additionally, on surfaces that have been treated with wax or some no
wax floors, the sheen may be removed by the heat and steam action. It is always recommended to test an isolated area of the surface to be cleaned before proceeding. We also recommend that you check the use and care instructions from the floor manufacturer.
Using the SmartSelectTM button (2), choose from one of the following applications:
The steam mop will select the correct volume of steam required for your particular cleaning operation.
NOTICE: SmartSelectTM has a memory. Switching the steam mop on will recall the previously used setting.
Steam Burst button - Fig. K
The steam burst button is a built in feature that aids in the removal of stubborn floor marks or stuck on grime.
• To apply an extra burst of steam to trouble areas, press the Steam Burst button (19). NOTICE: The steam burst will last for 10 seconds then the steam mop will return to the chosen setting.
7
