Black & Decker 90528116, BDTS200 instruction manual On the screw L Fig

3.Locate the 1/4-20x2 inch hex head screw (G) Fig. 18. Place the 1/4 inch internal tooth lockwasher (O) M6.4 flat washer (P) and the 1/4 inch external tooth lockwasher (R) on the screw (G).

4.Position the recessed end (E) Fig. 19 of the splitter bracket (B) against the end of the pivot rod (F), and fasten using the assembly in STEP 3. NOTE: Do not completely tighten screw (G) at this time. Assembly shown in Fig. 20.

NOTE: Loosely tighten the hardware for further adjustment.

5.Position the splitter (H) Fig. 21 against the splitter support bracket, making certain the two protrusions (K) on the splitter support bracket are inside the slot of splitter (H).

R

P

O

G

Fig. 18

G

Fig. 20

6.Attach the splitter (H) Fig. 22 to the splitter support bracket (B). Place a 1/4 inch external tooth lockwasher and an M6.4 flat washer on an M6x1x20mm hex head screw (L).

7.Insert the screw (L) Fig. 22 through the splitter support bracket (C) and the splitter (H). Place an M6.4 flat washer and a 1/4 inch external tooth lock washer on the screw (L). Thread an M6x1 wing nut

(M) Fig. 23 on the screw (L) Fig. 23.

F

E

B

Fig. 19

H

K

Fig. 21

C

L

H

B

Fig. 22

13