90539499 01 EM100B.qxd 7/7/08 10:05 AM Page 4
01 BEFOREYOU BEGIN
Verify the contents of the box.
Verify that your package contains all of the components shown below. If any item is
missing, please call
|
|
|
| |
|
|
|
| |
1 Rubber Shim |
| 1 Clear Alignment |
| |
3 Instruction | ||||
|
|
| ||
|
| Template | ||
|
|
| Manuals | |
|
|
| (English, Spanish | |
|
|
| and French) | |
| Digital Display | |||
|
| Stand | ||
|
| Meter Sensor | ||
Digital Display |
| (with clamping strap) | ||
You will also need:
Four (4) AA batteries (not included)
Do not use rechargeable batteries
Use lithium batteries in the sensor for best performance in freezing temperatures (below 32°F, 0°C)
Copy of your Electricity Bill
1 large Flat Head Screwdriver (not included)
A clean damp cloth (not included)
01 BEFOREYOU BEGIN
Digital Display Stand Keyhole Hanger
The Digital Display can be mounted to a wall using the keyhole hanger in the back, or it can stand alone using the plastic stand.
To attach the stand to the Digital Display, insert the plastic tabs into the square recesses on the lower back of the Digital Display as shown. Once all four tabs are in the recesses, push up on the stand to lock it in place.
Install Digital
Display Batteries
Remove the battery compartment cover on the back of the Digital Display, insert two AA batteries (not included) in the proper orientation, and replace the battery compartment cover.
Install Meter Sensor Batteries
Using a large Flat Head
Screwdriver, loosen the
slotted screw and open the Meter SensorStatus battery compartment cover. Insert two AA
batteries (not included) in the orientation indicated, then close the battery compartment cover and tighten the screw until snug.
About 10 seconds after installing the batteries, the status indicator will light up solid red, and the sensor will look for a signal from a meter. If the sensor is
not installed on a meter within 20 minutes, the status light will blink rapidly. This is normal, and you can press the RESET button to restart the search if your installation is interrupted.
Make sure that the battery closest to the Sensor Arm goes in with its positive end
(+) facing inward. Refer to (+) and
4 |
|
|
|
| 5 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
