90539499 01 EM100B.qxd 7/7/08 10:05 AM Page 32

09PROGRAM DIGITAL DISPLAY – TIME-OF-USE RATEBILLING

Note: Before you begin programming your Digital Display for Time-of-Use Rate Billing, you will need to refer to the Billing Rates and Time Slots you recorded in section 05.

STEP

ACTION/PRESS

DISPLAY

Select whether Time-of-Use

Billing applies on weekends.

Note: Flashing SUN and SAT indicate Time-of-Use Billing DOES NOT apply on weekends.

Enter Off-Peak Billing Rate.

To make the numbers change faster, you can press and hold the or .

For Three Rate (3-PEAK)

Billing only:

Enter Mid-Peak Billing Rate.

Enter On-Peak Billing Rate.

09PROGRAM DIGITAL DISPLAY – TIME-OF-USE RATEBILLING

Note: Before you begin programming your Digital Display for Time-of-Use Rate Billing, you will need to refer to the Billing Rates and Time Slots you recorded in section 05.

STEP

ACTION/PRESS

DISPLAY

Select which Rate Type applies to the first Time Slot.

Enter start time for second

Time Slot. Enter hours.

Then enter minutes.

/\ \/

Select which Rate Type

applies to the second Time Slot.

Continue this process to enter data for all Time Slots from your billing schedule in section 05.

If you have fewer than 6 time

slots, hold down prog/sync to exit

Program Mode.

Beep!

Enter start time for first

Time Slot. Enter hours.

Then enter minutes.

Continue on the top of the next page.

Programming is complete!

Go to Section 10, Using Your Power Monitor.

32

 

 

 

 

33

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 17
Image 17
Black & Decker em100b instruction manual Program Digital Display TIME-OF-USE Ratebilling