Product may vary slightly from what is illustrated.
| | | |
| | ||
| |||
| |
| |
|
| ||
|
| | |
| |
| |
| | | |
|
|
How to Use
This product is for household use only.
• Remove all packing material and any stickers from the product.
Important: Handle sharp chopping blade and slice/shred disc carefully. They are very sharp.
•Wash all removable parts as instructed in Care and Cleaning section of this manual.
•Select a flat, dry clean surface where this unit is to be used.
•Remove tie from cord and unwind.
•Plug unit into electrical outlet.
ASSEMBLING THE PROCESSOR
HOW TO LOCK THE BOWL IN POSITION
A
1.Place the workbowl over the center post in base with handle turned to the left on the base (B).
B
† | 1. | Continuous flow side chute (Part# |
† | 2. | Continuous flow stopper, (Part# |
† | 3. | Cover with feed chute (Part# |
† | 4. | Food fingers (Part# |
† | 5. | Food pusher (Part |
† | 6. | Feed chute |
† | 7. | Slice/shred disc (Part# |
† | 8. | Disc stem (Part# |
| 9. | Control dial (High/Low/Off/Pulse) |
† 10. | ||
| 11. | Center post |
| 12. | Base |
† 13. | Chopping blade (Part |
2.Hold handle and rotate workbowl counterclockwise until it clicks firmly into place (C).
| 3. Place desired blade assembly onto center post. (For | |
| specific blade assembly, see HOW TO CHOP IN THE | |
| WORKBOWL on page 5 or HOW TO SLICE OR SHRED | |
| INTO WORKBOWL on page 6; for continuous flow | |
C | operation, see HOW TO USE CONTINOUS FLOW SIDE | |
CHUTE on pages 6 and 7.) | ||
|
HOW TO LOCK THE COVER
1. Place cover over workbowl with feed chute to the right and continuous side flow chute slightly to the back left of the controls (D).
2.Hold handle and rotate cover counterclockwise until cover locks into place.
D
† 14. | Continuous flow discharge disc (Part# |
† 15. | Storage lid (Part# |
† Consumer replaceable/removable parts |
3
CONTROLS
E
Important: For your protection this appliance has an interlock system. The processor will not operate unless the workbowl and cover are properly locked in place. (See illustrations for assembling the processor.)
The control is located on the top of the base. Rotate the knob to select a function (E).
4