Black & Decker FP2510SKT manual Troubleshooting, Problem, Possible Cause, Solution

TROUBLESHOOTING

PROBLEM	POSSIBLE CAUSE	SOLUTION
Food is unevenly	Workbowl is overfilled.	Smaller amounts will
chopped.	You may be running	process more evenly.
	the bowl continuously	Use the PULSE (P) button
	instead of on PULSE	in 5-second or less
	(P). Food may be cut in	increments. Allow the
	random sizes.	blades to stop completely
		before pressing the
		PULSE (P) button again.
		Cut food in same size
		pieces before placing in
		processor.
Liquid leaks from the bot-	Too much liquid in the	Process smaller amounts.
tom of the workbowl.	workbowl.	When processing liquids,
		do not add more than
		3 cups to workbowl.
		Do not remove the
		blade before removing
		workbowl from processor
		when processing liquids.
Sliced foods are uneven	The feed chute has not	Cut pieces in even
and slanted.	been well packed or	lengths, just a little
	uneven pressure has	shorter than the length
	been applied to the food	of the feed chute. Pack
	pusher during processing.	the chute carefully and
		maintain even pressure
		on the food pusher as the
		food is being processed.
Foods being sliced or	This is normal.	Stop processing
shredded fill up on one		occasionally and either
side of the bowl.		even out the food in the
		workbowl or move it to
		another bowl. When food
		accumulates close to the
		disc, empty the workbowl
		before continuing.

PROBLEM	POSSIBLE CAUSE	SOLUTION
Some pieces of food	This is normal.	Slice or shred those
remain on top of the		pieces by hand or save
slice/shred disc.		for another use, like
		soups that will be pureed.
Soft cheese collects on	The cheese was not cold	Be sure soft cheeses are
top of the slice/shred	enough. The pressure	well chilled or place
disc.	exerted on the pusher	in freezer until knife
	was too great.	inserted into cheese
		penetrates about ½-inch.
		Remember food pusher
		is to be used as a guide;
		never exert hard pressure
		on the food pusher.

17 18