1.Switch
2.Cord Retainer
3.Cord Receptacle
4.Auxillary Handle
5.Collar (to adjust height and edge)
6.Motor Housing
7.Edge Guide
8.Guard
9.Spool
COMPONENTS
1
4 2
3
5
6
8
7
9
ASSEMBLY & ADJUSTMENT | |
ASSEMBLY TOOLS REQUIRED (NOT SUPPLIED): | |
- Phillips Screwdriver |
|
INSTALLING THE GUARD |
|
WARNING: UNPLUG THE TOOL BEFORE ATTEMPTING TO | |
ATTACHTHE GUARD, EDGE GUIDE OR HANDLE. NEVER | |
OPERATE TOOL WITHOUT GUARD FIRMLY IN PLACE. THE | |
GUARD MUST ALWAYS BE ON THETOOLTO PROTECTTHE | |
USER. | 1 b |
• Turn the trimmer upside | |
down so that you are looking |
|
down at the spool cap (a). |
|
• Turn the guard (b) upside | c |
down and slide it onto the | |
motor housing (c). Make | d |
sure the tabs (d) on the |
|
guard engage the ribs (e) on | e |
the motor housing as shown. | |
• Continue to slide the guard |
|
on until you hear it “snap” into |
|
place. |
|
• Using a phillips | a |
screwdriver, remove the | |
screw from the guard. | 2 |
• Insert the guard screw as | |
shown in figure 2 to |
|
complete the guard |
|
assembly. |
|
• Once the guard is installed, |
|
remove the covering from the |
|
line |
|
the edge of the guard. |
|
5 |
|